Flowter Pedal Hanger Minimal

Yes, the drilling jigs allow drilling right away and do not require awkwardly marking out holes. Also, the position of the wheel carriers is based on the pedal bearing and is therefore easy to determine.

No, the system has been developed with a high priority to prevent damage. During suspension, sturdy rubber supports the pedal and ensures that the pedal is softly caught. In addition, we are more often asked whether there is not too much weight on the axles of the pedals during suspension. Since the pedals are the point where all the cyclist’s weight comes to bear, the few kilos of a bike pulling on the pedals when suspended are negligible.

No, this is what the system is optimised for. The manual also refers to this article: https://flowter.co/fiets-ophangen/hoe-hang-je-drie-fietsen-horizontaal-boven-elkaar-op-de-muur/, where additional explanations are given about hanging multiple bikes above each other. Because the system is sliding and thus adapts to the space and bike, this is very easy.

A suspension system at the pedal without a sliding part is a very limited system. What if a larger or smaller bike is to be hung on that system instead of the current one? This then cannot be done because of the ratio differences. What if you want to hang the bike as tight as possible against the wall? With a non-sliding system, the pedal support area must be kept universal so that any type of pedal fits on the system. Which results in the bike always hanging far from the wall. Trying to hang three bikes on top of each other then only leads to irritation and you have to be lucky if the handlebars of the other bike don’t collide.

A sliding system is the solution. By being able to shift the pedal support part, the system adapts to the bike. Each type of pedal is different and the closer the pedal is to the wall, the more optimised it is suspended.

Tired of the bike currently hanging on the wall? And want to hang another one? Shift the two wheel carriers over the given wire, to a position that suits the bike. Is it a larger bike? Then move it to the lowest position.

Of course, the product has been fiercely tested for each type of bike. The sliding system on which the pedal rests was a particular point of focus for us. If you tighten the wing nuts properly and have drilled the installation material in properly, the heaviest e-bike can hang from it with ease.

We apply a maximum weight of: 30 KG. However, this varies depending on the material. The materials below should provide sufficient support for any type of bicycle if installed correctly. Nevertheless, if in doubt, we recommend purchasing hollow wall anchors for hollow materials.

The dowels supplied are suitable for: aerated concrete, solid brick and perforated, wood threaded bolt, sand-lime brick, aerated concrete, concrete, chipboard, natural stone, gypsum board, solid brick, perforated brick, light concrete hollow brick, hollow floor slabs made of bricks and concrete or equivalent and aerated concrete. For certain materials, there is a deviation in the maximum weight and will need to be checked on the fischer.co.uk website for the correct specifications.